Need help?Do you have a question about the YOKOGAWA DAQSTATION DX100P and is the answer not in the manual?
General| Type | Data Acquisition Station |
|---|---|
| Communication Interface | USB, Ethernet |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Operating Temperature | 0 to 50 °C |
| Display Type | Color LCD |
| Input Type | Thermocouple, RTD |
| Data Storage | Internal memory |
| Display Size | 5.7 inches |
Provides information on manual structure, trademarks, and revision history.
Details compliance with IEC safety class I and EMC standards.
Explains symbols used on the DXP and general safety warnings.
Covers precautions for batteries, software, and general instrument handling.
Outlines YOKOGAWA's disclaimer regarding product warranties and liability.
Explains the login function, administrator, and user registration.
Describes how measured data is acquired and saved to storage media.
Details the function to add approval information to measurement data files.
Provides precautions for instrument handling and external storage media.
Covers recommended installation locations and panel mounting procedures.
Details input signal wiring, power supply, and associated precautions.
Explains wiring procedures, terminal arrangements, and diagrams for models.
Describes the procedure for turning the DXP power switch ON and OFF.
Explains how to insert and remove external storage media from the DXP.
Provides a diagram of the main operational steps for measurements.
Identifies and explains the function of the DXP's keys and buttons.
Details how to enter numbers and characters using the DXP interface.
Guides on how to enter and exit the DXP's system mode for configuration.
Explains how to configure login functions and electronic signature settings.
Covers administrator registration, setup, and exiting system mode.
Details the steps for logging in as an administrator for the first time.
Explains setting the date/time and registering new users.
Covers configuration of other system mode items like scan interval and data type.
Describes the procedure for logging out of the system mode.
Guides on logging in as a user and setting measurement ranges.
Explains setting batch conditions and messages for measured data.
Details setting other engineering mode items and exiting the mode.
Covers starting measurements, setting batch numbers, lot numbers, and recording.
Explains how to manually log out using keys or via automatic logout.
Details how to write messages, either predefined or custom strings.
Guides on how to stop ongoing measurements and confirm data.
Details the procedure for applying electronic signatures to measured data.
Explains importing measurement data and viewing it using DAQSIGNIN.
Guides on confirming data and applying the electronic signature via DAQSIGNIN.
To Next Page