General Safety Practices
1 - 14
• Do not damage wiring during removal operations. Reinstall the wiring so it
is not damaged nor will it become damaged in operation by contacting sharp
corners, or by rubbing against some object or hot surface. Do not connect
wiring to a line containing uid.
• Be sure all protective devices including guards and shields are properly
installed and functioning correctly before starting a repair. If a guard or shield
must be removed to perform the repair work, use extra caution.
• Loose or damaged fuel, lubricant and hydraulic lines, tubes and hoses can
cause res.
• Do not bend or strike high pressure lines or install ones which have been bent
or damaged. Inspect lines, tubes and hoses carefully. Do not check for leaks
with your hands. Pinhole (very small) leaks can result in a high velocity oil
stream that will be invisible close to the hose. This oil can penetrate the skin
and cause personal injury. Use cardboard or paper to locate pinhole leaks.
• Tighten connections to the correct torque. Make sure all heat shields, clamps,
and guards are installed correctly to avoid excessive heat, vibration or
rubbing against other parts during operation. Relieve all pressure in air, oil
or water systems before any lines, ttings or related items are disconnected
or removed. Always make sure all raised components are blocked correctly
and be alert for possible pressure when disconnecting any device from a
system that utilizes pressure.
• Do not operate a machine if any rotating part is damaged or contacts any
other part during operation. Any high speed rotating component that has been
damaged or altered should be checked for balance before reusing.
• Caution should be used to avoid breathing dust that may be generated when
handling components containing asbestos bers. If this dust is inhaled, it can
be hazardous to your health. Components in Zamboni machine products that
may contain asbestos bers are brake pads, brake band and lining assemblies,
and some gaskets. The asbestos used in these components is usually bound
in a resin or sealed in some way. Normal handling is not hazardous as long
as airborne dust which contains asbestos is not generated.
• If dust which may contain asbestos is present, there are several common
sense guidelines that should be followed:
• Never use compressed air for cleaning.
• Avoid brushing or grinding of asbestos containing materials.
• For clean up, use wet methods or a vacuum equipped with a high
efciency particulate air (HEPA) lter.
To Next Page
Loading...