Zamboni 445 - Used Blade; Blade Controls on Conditioner; Side Controls

9 - 2
Maintaining the Cutting Blade
Used Blade
Use REAR mounting holes when blade is 4" wide or less.
Note: Hardened material is exhausted when blade is approximately 3" wide. Discard blade.
Blade Controls on Conditioner
Blade Height Adjusting Screws level each side of the blade in relation to the runners.
Side Controls
Figure 9.1 Blade Controls on Conditioner
Conditioner Runner
Down Up
Rear View
Conditioner RunnerBlade
Blade Height
Adjusting Screws