7 - 9
Operating the Ice Resurfacer
Using the Snow Breaker
The operator should use the snow breaker several times a minute (or more as required). The
snow breaker helps remove snow or ice that will build up in the corners of vertical auger
opening. To use the snow breaker, push down on the snow breaker rod and release. Repeat
this action several times.
The machine may also be equipped with an optional automatic snow breaker. It will
perform the above action six times per minute once turned on via the rocker switch. It also
has a manual override button should additional action be required.
Washing the Ice
The wash water system removes dirt and debris from the ice surface. Regular use of the
wash water system will produce a clean, high quality ice surface.
Before using the wash water system, ll the wash water tank with cold water.
To use the wash water system:
• With the conditioner down, the horizontal conveyor rotating, and the machine
moving forward, fully open the wash water valve. The wash water valve is
located on the right side of the conditioner.
• Allow the valve to remain open for at least 10 seconds.
• Turn on the wash water pump switch. The red light in the rocker switch
indicates that the wash water pump is operating. You should hear a click
sound when the clutch on the pump engages.
• You will be able to see the wash water ow into the wash water tank screen
basket located to the right of the operator's area. If there is no ow, turn off
the pump immediately. Check the system for obstructions after the machine
has been removed from the ice.
• When resurfacing has been completed, rst turn off the wash water pump
and then close the wash water valve. The conditioner can then be raised.
To avoid damaging the wash water pump impeller (caused by running it dry), always have
water in the wash water tank and always wait at least 10 seconds after opening the valve
before turning on the wash water pump. A burning rubber smell is an indicator of an impeller
that has been or is running dry.
After each resurfacing, inspect and discard any debris collected by the wash water tank screen.
Periodically inspect the rubber squeegee located at the lower rear of the conditioner for tears
and damage. Replace as required to maintain good wash water system performance. When
replacing the squeegee be sure to trim the edge around the conditioner runner as tightly as
possible. A sloppy cut will allow wash water to escape possibly creating a poor washing
action and leaving streaks on the ice.
To Next Page
Loading...