1 - 15
General Safety Practices
• Use exhaust ventilation on permanent machining jobs.
• Wear an approved respirator if there is no other way to control the dust.
• Comply with applicable rules and regulations for the work place (for
example in the U.S.A., OSHA requirements as set forth in a 29 CFR
1910.1001)
• Follow environmental rules and regulations for disposal of asbestos.
• Avoid area where asbestos particles may be in the air.
Battery Operation and Maintenance
WARNING!
Hydrogen and oxygen gases are given off as battery
plates get near a full charge condition. These gases
are highly explosive and caution must be taken to
make sure no arc, spark, or ame comes into contact
with the generated gases. The possibility of explosion
is always present with exposure of the battery to sparks
or ame, but is especially hazardous at the end of the
charging period.
WARNING!
When using air pressure for cleaning purposes, wear
a protective face shield and protective clothing.
Maximum air pressure must be below 30 psi (207 kPa).
Do not smoke near batteries that are being stored or
when checking the electrolyte level.
Electrolyte is an acid solution and can cause personal
injury. Avoid contact with skin and eyes.
Maximum life and performance of batteries is dependent on the operator, battery charging,
maintenance and service.
Most dirt and dust picked up by the battery can usually be blown off with low pressure
compressed air.
However, if cells are overlled and electrolyte collects on the covers, the top of the battery
will stay wet.
If necessary, clean the top of the battery with a solution of baking soda and hot water.
CAUTION!
Vent caps must be tight to prevent soda solution from
entering battery cell.
To Next Page
Loading...