7 - 5
Operating the Ice Resurfacer
Learning to Resurface
Before Going to the Ice
• Check the water level in the water tanks.
• The blade must be level (see Figure 9.5) and at the correct angle (see Figure
9.6).
• The conditioner must be raised completely.
• The towel bar should be attached if water is to be applied to the surface.
• NO RIDERS!
On the Ice
WARNING!
Do not operate the machine if anyone is on the ice.
The following operations may be performed while on the ice:
• Shaving or cutting.
• Washing the ice.
• Distributing ice-making water.
• Use of the board brush, edger, or other optional equipment.
• Removing excess water from the ice.
• Removing slush (mixed ice and water) from the ice.
To Next Page
Loading...