Table 3 – 3-pin terminal block pin-out
The maximum acceptable cable cross-section for the terminals is 1.5mm
2
.
SD card slot
The “push-push” SD card slot allows the use of a microSD card with maximum capacity of 8 GB. The
card is inserted and removed by simply pushing the card in. The microSD card is not on board the
device and is only required for specific applications, as specified by ZCS Technical Support.
Ethernet connector
The Ethernet connector with two LEDs enables network connection via cable. All Connext devices
are already set-up for connection either via the on-board SIM or via cable.
To Next Page
Loading...