Zebra 105Se User Manual

Media
Media Specifications 105Se 160S
Total media width Maximum 4.5" 114.3 mm 7.2" 182.9 mm
Minimum 0.75" 19.05 mm 2.0" 50.8 mm
Label length
Maximum Refer to Printing Considerations on page 1-6.
Minimum
Tear-Off 0.63" 16.00 mm 0.63" 16.00 mm
Peel-Off 0.50" 12.8 mm 0.50" 12.8 mm
Rewind 0.50" 12.8 mm 0.50" 12.8 mm
Cutter 1.25" 31.75 mm N/A N/A
Total
thickness
(includes
liner)
Maximum (Printhead po-
sition may need to be ad-
justed above 0.01")
0.015" 0.381 mm 0.015" 0.381 mm
Minimum 0.0023" 0.0584 mm 0.0023" 0.0584 mm
Core size 3.0" 76.2 mm 3.0" 76.2 mm
Maximum roll diameter 8.0" 203.2 mm 8.0" 203.2 mm
Interlabel gap (0.115"/3 mm preferred) 0.079" - 0.157" 2 mm-4mm 0.079"- 0.157" 2 mm -4 mm
Maximum internal fanfold media pack
size (LxWxH)
8.0" x 7.2" x
6.2"
203.2 mm x
182.8 mm x
157.4 mm
8.0" x 7.2" x
6.2"
203.2 mm x
182.8 mm x
157.4 mm
Additional Specifications for Black-Mark Media (optional on 105Se)
Mark thickness (measur-
ing parallel to label/tag
edge)
Minimum 0.12" 3 mm 0.12" 3 mm
Maximum 0.43" 11 mm 0.43" 11 mm
Mark width (measuring
perpendicular to label/tag
edge)
Minimum 0.43" 11 mm 0.43" 11 mm
Maximum Full media width. Full media width.
Mark-to-mark registration tolerance + /- 0.016" +/- 0.4 mm +/- 0.016" +/- 0.4 mm
Mark location Mark must be located on the inside of the media (closest to the
printers mainframe when loaded in the printer).
Mark density > 1.0 ODU (Optical Density Unit)
Density of the back of the media on
which the black mark is printed
0.5 ODU maximum
Zebra S-Series User’s Guide 1-7
15

Zebra 105Se Specifications

General

Brand	Zebra
Model	105Se
Category	Printer
Language	English