Preventive Maintenance
Overview
This section contains preventive maintenance information for the Zebra
S-Series Printer. These procedures may be performed by the operator.
Cleaning
Exterior Surfaces
The exterior surfaces of the printer may be cleaned as required by using
a lint free cloth. Do not use harsh or abrasive cleaning agents or sol-
vents. If necessary, a mild detergent solution or desktop cleaner may be
used sparingly.
Interior
Remove any accumulated dirt/lint from the interior of the printer using
a soft bristle brush and/or vacuum cleaner. This area should be in-
spected after every four rolls of media.
Zebra S-Series User’s Guide 6-1
AREA METHOD INTERVAL
Printhead Isopropyl alcohol After every roll of media (or 500
ft. of fanfold media) when print-
ing direct thermal or after every
roll of ribbon when printing in
thermal transfer mode.
Platen Roller Isopropyl alcohol
Upper and Lower
Media Sensors
Air blow
Media Path Isopropyl alcohol
Ribbon Sensor Air blow
Peel/Tear Bar Isopropyl alcohol As needed.
Label Available Sensor Air blow Monthly.
Cutter Module Isopropyl alcohol and/or air blow As needed.
Table 6.1 Cleaning Schedule
65
To Next Page
Loading...