Optional Printer Fonts
The S-Series Printer can be optioned with character fonts in addition to
those which are standard in the unit.
Only one additional font can be installed in the printer at a time. This
installation should be performed by a service technician. Once in-
stalled, this font can be used in addition to the standard fonts available
in the printer. Refer to the ZPL II Programming Guide for further ap-
plication information.
Once an optional font is installed in the printer, the Configuration print-
out from the CANCEL Key Self Test will indicate the font type.
The following optional scalable smooth fonts are presently available
(each is supplied as a complete set of standard, bold, italic, and bold
italic styles): CG Triumvirate™, CG Times™, CG Palacio™, Futura™,
Univers
®
.
The following Bitmap Smooth Fonts (supplied in bold style only) are
presently available:
CG Triumvirate™ Bold, CG Triumvirate™ Bold Condensed, Futura™
Bold, Univers
®
Bold, CG Times™Bold and CG Palacio™ Bold (type
sizes of 6 pt, 8 pt, 10 pt, 12 pt, 14 pt, 18 pt, 24 pt, 30 pt, 36 pt are avail-
able.)
Examples of these optional fonts can be found in “Appendix D.”
230 VAC Factory Setup
Your Zebra S-Series Printer will be factory set for 230 VAC operation
if requested when the order is placed. If it is necessary to reconfigure
your printer for operation at 115 VAC, see “Installation.”
Zebra S-Series User’s Guide 9-3
83
To Next Page
Loading...