Zebra 105Se - PAUSE Key Self Test 3-10; PAUSE Key 3-10

CANCEL Key Self Test
This self test prints a single label which contains a listing of the
printer’s current configuration parameters stored in Configuration
(EEPROM) Memory. Press the CANCEL key while turning the AC
Power Switch ON. See Figure 3.2.
The configuration may be changed
either temporarily (for specific label
formats or ribbon and label stock), or
permanently (by saving the new pa-
rameters in EEPROM Memory). Sav-
ing new parameters occurs whenever
a Printer Calibration procedure is
performed. Refer to the procedure
in“ConfigurationandCalibration.”
Zebra S-Series User’s Guide 3-9
Figure 3.2 CANCEL Key Test
Sample Printout
45