Clean the stationary cutter blade with a cotton swab moistened with iso-
propyl alcohol when it becomes gummed up with label adhesive or pa-
per debris. If the cutter performs unsatisfactorily after it has been
cleaned, refer to Volume 1 of the Maintenance Manual.
Lubrication
CAUTION: Some commercially available lubricants will damage the
printer if used.
Lubrication of the Zebra S-Series Printer should be performed by a
qualified service technician according to the directions provided in the
Volume 1 of the Maintenance Manual (part # 38452L).
6-4 Zebra S-Series User’s Guide
Figure 6.2 Cleaning the Cutter Blade
68
To Next Page
Loading...