Zebra 105Se - Cutter Module 6-3; Sensors 6-3

Printhead and Platen Roller
Inconsistent print quality, such as voids in the bar code or graphics, may
indicate a dirty printhead. For optimum performance, Zebra recom-
mendsperformingthecleaningprocedureonpage6-3aftereveryroll
of ribbon (after every roll of media, for direct thermal printing).
Note: Label Available Sensors are shown for location purposes only.
They are not standard on all printers.
6-2 Zebra S-Series User’s Guide
Figure 6.1 Printhead Cleaning (105Se shown)
66