Removing Used Ribbon (160S)
Refer to Figure 2.10.
1. Turn the knob at the end of the Ribbon Take-Up Spindle (1) clockwise
until it stops. This will cause the Ribbon Release Bars to pivot down
(2), easing the spindle’s “grip” on the wound ribbon.
2. Slide the ribbon off of the Ribbon Take-Up Spindle. Once the used rib-
bon has been removed, ensure that the arrow on the knob aligns with
the indented notch in the Ribbon Take-Up Spindle (see inset).
3. Remove the empty core from the Ribbon Supply Spindle.
4.Followtheribbonloadingprocedureonpage2-7toloadthenewrib-
bon.
Zebra S-Series User’s Guide 2-13
Figure 2.10 Removing Used Ribbon (160S)
35
To Next Page
Loading...