Bank 1 (For Serial Interface Printers Only)
The S-Series Printer, with the
RS-232 Serial Interface, uses
eight miniature switches located
on the rear of the printer, above
the Signal Interface Cable Con-
nector. The ON/OFF positions
of these switches establish some
of the Printer Configuration Pa-
rameters. Bank 1 switches must
be properly positioned to estab-
lish serial data communications
with the host computer. There-
after, the position of these
switches should not be changed.
Note: Parallel-interface
printers do not require
these configuration
parameters, therefore
they have no Bank 1
switches.
If these switches are in the
proper position to match the
communication configuration of
the host computer, and the
printer is not receiving data, re-
ferto“Interconnections”and
make sure the correct interface
cable is being used.
Note: The printer is fixed at 1
stop bit, so make sure
that your host device is
also set at 1 stop bit.
4-2 Zebra S-Series User’s Guide
Bank 1
(Serial Interface Printers Only)
Switch
321
Baud Rate
RRR
9600 baud
RRL
19200 baud
RLR
110 baud
RLL
300 baud
LRR
600 baud
LRL
1200 baud
LLR
2400 baud
LLL
4800 baud
Switch
4
Data Bits
(
Must be set to 8 Data Bits to use Code
Page 850.
)
R
7 Data bits
L
8 Data bits
Switch
65
Parity
(If you choose 7 data bits, you must
choose either even or odd parity.)
RR
Even parity
RL
Parity disabled
LR
Odd parity
LL
Parity disabled
Switch
7
Communication
Handshake Control
R
XON/XOFF control
L
DTR/DSR control
Switch
8
Error Detection Protocol
R
No error detection
L
Error detection active
Table 4.1
54
To Next Page
Loading...