130 Preparations
G-30-1529-en OPMI® VISU 160 on S8, S81 & S88 Suspension Systems Issue 5.0
Printed on 09. 10. 2006
Changing the microscope accessories
You can change the microscope accessories in reverse order to that de-
scribed before. Please observe the following:
• Turn off the unit at the power switch before changing any accessories.
• Bring the suspension arm in a position convenient for you and firmly
tighten locking knob (1).
• After changing the accessories, re-adjust the friction as required.
Warning!
– Before every use and after re-equipping the instrument, make sure
that binocular tube (4) is securely locked in position. Make sure that
securing screw (3) and objective lens (2) have been firmly
tightened!
– Re-adjust the balance of the suspension arm after every change of the
equipment.
To Next Page
Loading...
