EN
6. Installing Your Hyper 2000 Hybrid Inverter
6.1 Pre-assembly
This user guide only describes the cable connection method and assembly of the Hyper 2000 hybrid
inverter. To install solar modules, please read the instructions for the solar module and accessories.
We recommend carrying out any solar-related setup on a sunny day, as it will be easier to assess the
performance of your system and check for any issues.
Choose a location for the Hyper 2000 hybrid inverter
Make sure the Hyper 2000 hybrid inverter is within the Wi-Fi coverage area.
The antenna casing on the device needs to be at least 15cm away from the wall.
Please install the Hyper 2000 within the length range of the solar panel and 3m AC connection cables,
otherwise an extension cable may be required.
≥15cm
≤3m
To Next Page
Loading...