Zendure SolarFlow Hyper 2000 - Page 5


EN
7. 
8. For safety purposes, please use only the original charger and cables designed for the equipment. We are
not liable for damage caused by third party equipment, and this may render your warranty invalid.
9. 
10. During the operation of the solar energy system, avoid direct sunlight to prevent the Hyper 2000 hybrid
inverter from overheating. Do not place the Hyper 2000 hybrid inverter near any heat source.
11. 
people.
12. 
13. 
Since the Hyper 2000 hybrid inverter relies on the shell to dissipate heat, exposing the enclosure to
excessive heat will lead to damage.
14. To reduce the risk of damage to the electric cords and connectors, pull the connectors rather than the cord
when disconnecting the product.
15. 
persons.
16. 

17. Do not operate the product with a damaged cord or plug, or a damaged output cable.
18. 

19. 
20. Do not attempt to replace the internal components of the equipment by any unauthorized personnel. Have

that the safety of the product is maintained.
21. The Hyper 2000 hybrid inverter has a protection level of IP65, so the product cannot be immersed in liquids.
If the product accidentally falls into water during use, please place it in a safe and open area and stay
away from it until it is completely dry. The dried product should not be used again and should be properly
disposed of according to the disposal guidelines in this manual.
22. The product may feel warm when it’s working. This is a normal operating condition and should not be a
cause for concern.
23. To reduce the risk of electric shock, disconnect the solar photovoltaic panels, batteries, and home grid
before attempting any instructed servicing.
24. When charging the battery, work in a well-ventilated area and do not restrict ventilation in any way, as
inadequate ventilation may cause permanent damage to the equipment.
25. Do not clean the product with harmful chemicals or detergents. Only clean it with a dry cloth.
26. Do not move or shake the unit while operating as vibrations and sudden impacts may lead to poor
connections to the hardware inside.
27. Ensure that the Hyper 2000 hybrid inverter and the batteries are installed securely to avoid accidents and
product damage caused by falling.
28. 
29. Servicing of batteries should be performed or supervised by personnel knowledgeable about batteries and
the required precautions.