Option Installation
The process to upgrade the Model 6300 is two-fold. First, Zetron must be contacted in
order to purchase and obtain an upgraded license file. The license file is unique to a
specific Model 6300, based on its MAC address. The MAC address must be provided to
Zetron. Second, the unique license file is installed into the Model 6300.
♦
To obtain a license file
1. Log into the Model 6300 web configuration.
a. Use a computer connected to the IP Gateway through the network or by a
crossover cable.
b. Connect to the IP Gateway by entering its IP address in your web browser’s
address bar. The default address is 192.168.0.1.
c. If prompted for a password, enter it. The factory-configured password is
8206363.
Tip
If the IP address or password doesn’t work, a DIP switch can be set to force
the IP Gateway to run with a factory hard-coded password and IP address (see
DIP Switches on page 18). Ensure that power is removed when changing DIP
switch set
tings.
2. Click Option Installation. The Option Installation page indentifies the installed
licenses and displays the unit’s unique MAC address.
3. Make a note of the MAC address.
4. Contact Zetron in order to purchase an upgrade license. You must provide the
MAC address from the Option Installation page. Contact information can be
found at http://www.zetron.com
.
5. Zetron will provide you with a license file unique to the Model 6300 with the
specified MAC address. The license file usually has the file extension “.zlic”.
♦
To install a license file into the Model 6300
1. Remove power from the unit and open the cover.
2. Install jumper JP5 in order to enable write flashing (see Figure 4 on page 19).
3. Close the cover.
4. Set DIP switc
h C to the down position (see Table 1 on page 18).
5. Restore powe
r to the unit.
6. On a PC connected to the IP Gateway, copy the content of the license file:
a. Use Windows Notepad to open the license file provided by Zetron.
b. In Notepad, press CTRL-A to select the entire content of the license file. The
entire content should now be highlighted.
c. Press CTRL-C to copy the selected content to the clipboard.
7. Log into the Model 6300 web configuration:
a. Use a computer connected to the IP Gateway through the network or by a
crossover cable.
47
To Next Page
Loading...