138
HITCHES
F 198 F 199 F 199a
TOP LINK
Top link (1) is length adjustable within
range 270 mm. This is attached to the
tractor into one from four openings of
support (2), that transfers impulses
(senses) from attached implement to the
torsion shaft located in hydraulic
rock-
shaft.
Tractor equipped with electro-hydraulic
has the rigid bracket (A) with two
openings only.
TOP LINK
Pay attention to keep the same
length of joints screwed out from
the link tube when prolonging the
top link.
SELECTION OF TOP LINK POSITION
Attachment of top link into one from
openings 1 - 4 influences the following:
- sensitivity of hydraulic response
(control mode selection lever in
position "D" or " M"). The biggest re-
sponse sensitivity is with top link in
the opening "1".
- tilting the agricultural Implement when
being in lifted position with regard to
the height of implement frame (460
mm - 610 mm). The smallest tilting is
with top link in the opening "1".
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
