56
ELECTRONIC ENGINE GOVERNOR
RPM10 RPM11 RPM12
1.
In case the minimal engine speed is
being entered it is not possible to
enter the value higher than 1500
RPM. If you will try it the system will
automatically enter 1500 RPM.
2. In case the maximal engine speed is
being entered it is not possible to
enter the value smaller than 1500
RPM. If you will try it the system will
automatically enter 1500 RPM.
Two values can be entered into
permanent memory i.e. chosen minimal
and maximal engine speed. These
values will be memorized in the
permanent memory even after stopping
the engine and removing the key from
the key switch.
If you will enter the new minimal and
maximal engine speed into the
permanent memory the previously
entered values will be deleted and
replaced by new ones i.e. new values
set by you.
PERMANENT MEMORY RECALL - H/O
LAMP IS OFF
1. Indicator lamp H/O is off.
2. Press the keypad MIN or MAX
(depending if you want to recall
maximal or minimal speed entered in
memory) and keep it pressed (longer
time than 0,5 sec.).
3. Indicator lamp H/O turns on. Memory
is recalled. Engine will maintain the
recalled constant speed.
Engine speed can be set after this action
by:
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
