66
OPERATION
F 85 F 86 F 87
STARTING THE ENGINE EQUIPPED
WITH ELECTRONIC THERMOSTART
Tractors Z 11641 are equipped
with electronic
thermostart as a
standard.
Thermostart enables starting the engine
at lower temperatures. Time of glowing
and the process of fuel ignition in suction
manifold is controlled automatically.
Note: Before proper starting we recom-
mend to prime the fuel system by se-
veral strokes of fuel delivery pump.
1. Insert the key into the key switch
("0" position).
2. Depress the clutch pedal.
3. Move the main shifting lever and
reversor lever into neutral.
4. Turn the key through "I" position into
"II" position and (start) crank the
engine only (when “hot starts„ this
point can be eliminated).
5. Turn the key into "I" position. Yellow
indication lamp on the dashboard is
“ON“. The indicator lamp indicates
correct function of thermostart
glowing (when higher ambient tem-
peratures the thermostart function is
not initiated).
6. Wait until the indication lamp is off.
7. Turn the key into "II" position (start).
8. Release the key immediately after
starting the engine. Do not start
longer time then 10 sec.
9. After starting the engine, avoid run-
ning the engine at high speed.
PDF byl vytvoren zkusebnı verzı FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
