149
SETTING THE FRONT WHEEL TOE-IN
F 214
FRONT WHEEL TOE-IN AT NON-
DRIVEN AXLE
Correct toe-in of front wheels is 3 to 9
mm at tractor with non-driven axle.
Check and eventually adjust the play of
front wheel bearings before toe-in
checking. Inflate tires to the prescribed
pressure. Front wheel toe-in is
measured on sides of tires. The toe-in
"S" is calculated as a difference of
measured values: S = B ’ A (or S = b -
a).
FRONT WHEEL TOE-IN AT DRIVEN
AXLE
Correct toe-in of front wheels is 0 up to 2
mm at tractor with driving axle. Front
wheel toe-in is measured on front wheel
hubs (if assembled wheels the wheel
toe-in can be measured on rims).
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
