178
MAINTENANCE INSTRUCTIONS
E731
E732
AFTER DRAINING THE OIL
1. Replace the oil filter cartridge (1).
2. Check the state of sealing rings of
drain plugs and/or replace them with
new ones.
3. Mount all drain plugs.
4. Fill 60 litres of oil.
5. Start the engine and let it run for
about 2 minutes.
6. Stop the engine and when the oil
level in the gearbox is stabilized, fill
necessary amount of oil up to the
stated level.
7. Check a proper oil volume in gearbox
(in dependence on tractor operating
conditions).
8. *Checking and filling screw of half-
axle case (valid for standard portal
setting)
FRONT PTO SHAFT
Oil checking and filling plug (1) is placed
on the front side of the front PTO case.
After removal of the check screw,
the oil level must reach the lower
edge of the check hole.
To Next Page
Loading...
