179
MAINTENANCE INSTRUCTIONS
E733 E734 E735
LUBRICATING AND FILLING POINTS
OF FRONT DRIVING AXLE
1 - Lubricating nipple of kingpin
2 - Sliding bearings (2 pieces) of front
driving axle
3 - Drain hole of axle final drive housing
4 - Oil filler and check hole of axle final
drive housing (after dismounting the
check screw, the oil level must reach
the lower edge of the check hole)
OIL FILLER, CHECK AND DRAIN
HOLE OF THE FRONT WHEES
REDUCTION GEARS
Oil checking, filling and draining is
performed by means of one hole after
turning the reduction accordingly with the
figure.
1. Oil level check – hole in reduction
horizontal axis (after removal of the
check screw, the oil level must reach
the lower edge of the check hole)
2. Oil filling – hole up
3. Oil draining – hole down
BRAKE FLUID REFILL
Keep the brake fluid level at 3/4
of tank capacity (minimum level).
− Keep strict cleanness when handling
the brake fluid.
− Inspect brake fluid level daily before
the drive.
− Add the brake fluid through the filler
strainer.
To Next Page
Loading...
