67 Installation and Operating Instructions V04
13 Dismantling the Inverter
Below is the procedure for dismantlng the inverter out of service:
①Disconnect the inverter from all voltage sources (see Section 8).
②Remove the AC cable from the inverter.
③If a network cable is connected, remove the cable from theinverter.
④If other cables (e.g. smart meter connection) are connected, remove them from
theinverter.
⑤If a WiFi antenna is connected, remove them from theinverter.
⑥ Reclose the cover and tighten the 4 fixing screws.
⑦Unscrew and remove the 2 blocking screws located on the sides of the inverter.
⑧Raise the inverter to remove it from the wall bracket.
⑨ Remove the wall bracket.
If the inverter is disassembled due to a device replacement, it is not necessary
todismantle the wall bracket.
⑩If the inverter is to be stored or shipped in packaging, pack the inverter.
Use the original packaging or packaging that is suitable for the weight and
dimensions of the inverter and thenseal them by using adhesive tape.
Risk of burns due to hot housing and heat sink
To Next Page
Loading...
