ZiLOG System 8000 Hardware Reference Manual

HRM
Zilog
HRM
The user stack is used whenever a JUMP or GO command is exe-
cuted. The command must be set to some address within writ-
able memory. If the JUMP or GO address has a system break-
point set, it does not cause suspension of execution.
5.9.2. Monitor Program: The following conventions are used
in command descriptions:
< > Angle brackets enclose descriptive names for the quan-
tities to be entered.
[ ] Square b~ackets denote optional quantities.
A bar denotes an OR condition. For example, WIB means
either W or B can be used.
<CR> Carriage Return and line feed.
[ A single square left bracket is the monitor prompt.
% Symbol for hexadecimal value, for example %4F or %4FFF.
Apply the following when entering commands and options:
1. All commands and options must be entered in uppercase.
2. Commands can be abbreviated to the first letter.
3. Numbers are represented in hexadecimal notation.
4. The first character typed on a new line identifies
which command is being invoked. If an invalid charac-
ter is entered, a "?[" is displayed, prompting a new
command.
5. Addresses are specified by an optional segment number
in angle brackets, followed by a hexadecimal address.
If no segment number is specified, segment 0 is
assumed. For example, <00>4000 or 4000, <00>0 or 0,
<01>F800 or F800 for segment O.
5.9.3. Mon:itor Mode Commands: A summary of the commands in
the Monitor Mode are as follows:
5-16
Zilog
5-16

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English