ZiLOG System 8000 - Page 295

HRM
EXAMPLE:
DINT
READ
Zilog
HRM
The READ command is issued in polled mode.
COMMAND: EOFFSET I DOFFSET
DESCRIPTION:
EOFFSET enables use of head offsets during retries.
CM:NO is set to 0 on all subseqeunt packet commands~
This is the default mode for SMDMON.
DOFFSET disables head offsets during retries. CM:NO is
set to 1 on all subsequent packet commands.
EXAMPLE:
DOFFSET
READ
During the READ and all subsequent packet commands, no
offsets are used during retries.
COMMAND: EPAUSE I DPAUSE
DESCRIPTION:
EPAUSE enables a pause-on-error mode in SMDFMT. If
SMDFMT detects an error upon command completion or a
compare error, it will pause and request entry of a
<CR> to continue. This is useful when a command line
with a large repetition count is entered, and the test
is to halt temporarily when an error is detected.
DPAUSE turns off the PAUSE feature. It is the default
condition in SMDMON.
EXAMPLE:
EPAUSE
1000 (SALL 0 0 0)(589(7(32«READ 1 0 512)(ISEC 1»»»
The second command line reads the entire disk sector-
by-sector 1000 times. The user wants the test to halt
if an error occurs during the READ, and so EPA USE is
entered before the command line.
A-64
Zilog
A-64