ZiLOG System 8000 - Page 312

HRM
Zilog
(tracks are numbered 0-3).
HRM
(3) WRITE 1 AOOOH 1000H
If this command is executed after examples 1 and 2, it
writes 1000 hex bytes of data, starting from location
AOOO of segment 1, onto track 1 of the tape.
(4) 4((1WOFF 1000H) (WRITE)) (WFM)
If this command is executed after examples 1, 2, and 3,
locations BOOO through EFFF of segment 1 are written as
the second through fifth blocks of track 1. Ea.ch block
is 1000 hex bytes long, and there is a file mark ter-
minating this file. This illustrates the use of
parentheses, implied parameters, and repetition counts.
COMMAND DESCRIPTIONS
The following list of command3 are used in TCUMON. All
parameters, when applicable, are indicated as lowercase
variable names. All variables are assumed to be hexadecimal
numbers. If the conditions described under dependencies are
not met, the command will be rejected.
COMMAND: CEe
Description
CEe clears all command, lap, and error cou~ters.
Dependencies
None
COMMAND: ece
Description
eec clears all command counters.
Dependencies
None
A-81
Zilog
A-81