ZiLOG System 8000 - Page 82

HRM
Zilog
HRM
(4) ECC Test - Tests the system's error detection capabili-
ties.
(5) Peripheral Equipment Test - Does a cursory check of the
Winchester Disk and Tape Cartridge Controllers.
If SPUD detects a problem with the system, an error message
is displayed on the console of the system administrator
(ZEUS super-user). Table 3-3 lists the error messages .and
descriptions.
A possible solution to a power-up error condition is to
check that all cable connectors are properly mated, and that
all system boards are seated in their backplane connectors.
If problems still exist, run the SADIE diagnostics described
in Section 5, Maintenance.
3-31
Zilog
3-31