MiniAC Plus User Manual
P a g e | 65 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
10.1 Access Control Options
To set the parameters of the control lock of the terminal and related equipment.
Click Access Control Options on the Access Control interface.
Select whether to enable the Gate Control Mode. When it is enabled, the Door Lock
Relay, Door Sensor Relay and Door Sensor Type will not be displayed.
The device controls the opening duration of the electric lock. Valid value: 1~10
seconds;0 second represents disabling the function.
If the door is not closed and locked after opening for a certain duration (Door Sensor
Delay), an alarm will be triggered. The valid value of Door Sensor Delay ranges from 1 to
255 seconds.
There are three types: None, Normal Open, and Normal Closed. None means door sensor is
not in use; Normal Open means the door is always opened when electricity is on; Normal
Closed meansthe door is always closed when electricity is on.
The supported verification mode includes password/face, User ID only, password,
face only, and face + password.
Door Available
Time Period
The time period when the user can open the door, it can be set to any of the 50 time
rules.
To Next Page
Loading...
Need help?
General
