ZKTeco MiniAC Plus User Manual

MiniAC Plus User Manual
P a g e | 72 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
Out Anti-passback
After a user checks out, only if the last record is a check-in record can the user check
out again; otherwise, the alarm will be triggered. However, the user can check in
freely.
In Anti-passback
After a user checks in, only if the last record is a check-out record can the user check
in again; otherwise, the alarm will be triggered. However, the user can check out
freely.
In/Out Anti-
passsback
After a user checks in/out, only if the last record is a check-out record can the user
check in again, or a check-in record can the user check out again; otherwise, the
alarm will be triggered.
10.6 Duress Options Settings
If a user activated the duress verification function with specific authentication method(s), when he/she is under
coercion during authentication with such method, the device will unlock the door as usual, but at the same
time a signal will be sent to trigger the alarm.
Click Duress Options on the Access Control interface.
Item
Description
Alarm on
Password
When a user uses the password verification method, an alarm signal will be
generated, otherwise there will be no alarm signal.
Alarm Delay (s)
Alarm signal will not be transmitted until the alarm delay time is elapsed. The
value ranges from 1 to 999 seconds.
Duress Password
Set the 6-digit duress password. When the user enters this duress password for
verification, an alarm signal will be generated.

ZKTeco MiniAC Plus Specifications

General

Brand	ZKTeco
Model	MiniAC Plus
Category	IP Access Controllers
Language	English