Zodiac VORTEX-PRO VX40 - Section 8. Troubleshooting; VX40 Troubleshooting with Information LED; VX55 4 WD Status and Error Codes

Section 8. Troubleshooting
8.1 Using the Information LED for Troubleshooting (VX40 Cleaner)
The Information LED on the control box flashes in a specific sequence to indicate one of three
possible cleaner malfunctions.
Information LED Flashing Solution
LEDashesoncewithonesecond
interval.
Unplugtheoatingcablefromthecontrolboxandreconnect.
Iftheproblemisnotresolvedthroughtroubleshooting,contactZodiacAfter
SalesSupportat1300763021.
LEDashestwicewithonesecond
interval
Turncleanerwheelstoensuretheyarenotjammed.
Checkbrushesfordebris.
Startanewcleaningcycle.
Iftheproblempersists,contactZodiacAfterSalesSupportat
1300 763 021.
LEDashesthreetimeswithone
secondinterval
Checkpropellerfordebris.
Cleanthelter.
Startanewcleaningcycle.
Iftheproblempersists,contactZodiacAfterSalesSupportat
1300 763 021.
8.2 Viewing Cleaner Status Information for Troubleshooting (VX55 4WD only)
Information about your cleaner's current status and any relevent error condition is available through a
troubleshooting status screen. After cycling through each message, control box returns to current day and time
display. To view cleaner status information:
1. Remove cleaner from the pool and turn power off.
2. Press and atthesametimeandholdforatleastve(5)seconds.
The following cleaner operation messages are displayed consecutively for three (3) seconds:
Total hours cleaner has operated since new.
Last error code (if cleaner has had at least one error).
Time (in operating hours) the error occurred.
21
H0516700_REV A