Zodiac VORTEX-PRO VX40 - Section 4. Operation

Figure 13. Remove Protective Cap
Figure 14. Connect Power Cable
2. Gripthenotchedendoftheoatingpower
cable, insert into the control box, and turn
clockwise to tighten. (Figure 14.)
NOTE: Toavoiddamagingthepowercable,donottryto
twisttheentIrecablehousing(seebelow).
NOTE: Toavoidexposingthepowercableconnectorpins
towater,besuretheconnectorisscrewedinallthe
wayandthereisnogap.(seebelow).
Section 4. Operation
CAUTION
Topreventdamagetothecleaner,besuretoadhere
tothefollowingguidelines:
• Removethecleanerfromthepoolafterthe
cleaningcycleiscompletedandstoreonthecaddy
outofdirectsunlightorinclementweather.
• Neverliftthecleaneroutofthepoolbythefloating
cable.Alwaysusetheliftfeaturetoremovecleaner
fromthepool.
• Takeadditionalcarewhenliftingthecleaneroutof
thepool.Itbecomesheavierwhenfilledwithwater.
• Alwaysremovethecleanerfrompoolwhensuper
chlorinatingoraddingacid.
• Donothandlecleanerwhileitisinoperation.
IMPORTANT
• Alwaysmakesurethecleanerheadisfully
submergedbeforeyoubeginoperation.
• Cleanthefiltercanisteraftereachcleaningcycle.
• Donotleaveyourcleanerinthepoolona
permanentbasis.
• Attheendofeachcycle,removethecleanerfrom
thepool.Startatthecleanerheadanduntangleany
coilsinthecablebeforestoringthecleaner.
H0516700_REV A
8