ZOLL PD 2000 - Page 33

CHECKOUT PROCEDURES
With a new, fully charged battery, the charge time should be less than 10
seconds.
Mark the Checkout Procedure Data Sheet.
e When the charge tone is sounded, depress and hold the
DISCHARGE buttons on the paddles (for at least 5-10 seconds).
The PD™ 1400-series device will not discharge (because there is no ECG
wave to SYNC on).
Mark the Checkout Procedure Data Sheet.
« Reconnect the ECG cable to the PD™ 1400-series device.
7.7 TEST PROCEDURE
WARNING
e All persons near the equipment must be warned to
“STAND CLEAR” prior to defibrillator discharge.
» Press and hold the paddle DISCHARGE buttons.
Observe:
The defibrillator discharges.
The ECG waveform should return to baseline within 4 seconds.
The energy displayed on the defibrillator analyzer should be
324 - 396].
The delay time displayed on the defibrillator analyzer is 50 ms or
less.
Mark the Checkout Procedure Data Sheet.
* Repeat for all energy settings.
(The limits are +/-15% or 4 Joules, whichever is greater).
1-21