Use the MODULE keys to switch ON or OFF the
effect module you want to select.
In Edit mode, the module cursor LED's light for the effect module
that is currently ON. Also, the module cursor LED's flash for any
effect module being edited. By pressing the MODULE
keys, you can make the module cursor LEDs to the right or left
flash instead.
Press the GROUP key to switch the effect module
ON/OFF.
When you press the GROUP key, the selected effect module
switches ON or OFF. The module cursor LED's go out for any
effect module that has been switched OFF.
If you have chosen any of the currently OFF effect modules to edit, the
parameter value will be displayed as "--".Further, the unlit period for
the flashing module cursor LED is somewhat longer than for the
module that is ON. This display indicates that the effect module is
currently OFF and cannot be edited.
• Effect module ON/OFF can be stored as part of a patch. Do this
whenever necessary. (See page 19 for details.)
• You can also switch effect modules ON/OFF by using the BANK foot
switch and the Foot Switches 1 – 4. For details, see page 22 .
To Next Page
Loading...
Need help?
General
