In Play mode, regardless of the selectable patches, the final volume output by the 3030 can be controlled by the
Master Volume.
Adjusting Master Volume
■
8
LET' S LISTEN TO SOME PATCHES
Press either the VALUE + or VALUE – key.
The display will indicate the current value (0 – 50) of the Master
Volume.
While the value is displayed, continue pressing the
VALUE + / – keys to adjust the volume to the best
level.
• The Master Volume setting works in common for all the patches.
Storage cannot be done for separate patches.
• If you want to change the volume for specific patches, adjust the patch
level in Edit mode. For details, see page27.
• To increase the value rapidly, hold the VALUE+ key down while
pressing the VALUE – key. To decrease the value rapidly, hold the
VALUE – key down while pressing the VALUE+ key.
• This Master Volume parameter is valid for all patches. The value is
maintained even when the patch is switched. However, if the value is
not stored before power-off, the value at the next power-on will be the
same as that before adjustment.
• To store the value, select one of the USER group patches, and then
store it. (For the storing procedure, see page 19.)
2
1
To Next Page
Loading...
Need help?
General
