■
19
CHANGING PATCH TONE
Press the STORE key.
This will invoke the store standby status, and the module cursor
LED's, and parameter cursor LED's, will flash. In this status, you
can specify the bank number and patch number of the storage
destination.
Even though you can change the parameters of the patches of the
PRESET group, you cannot write over them. Instead, when you have
changed a patch of the PRESET group, select the storage destination
forcibly with "U" (USER group).
You can store in either Play mode or Edit mode.
Using the BANK foot switch and Foot Switches 1 – 4,
specify the patch storage destination.
If you do not make any particular specification, the destination
will be the original patch of the USER group. When store has not
been specified by the PRESET group, the patch is stored in
Patch 1, Bank 0 of the USER group.
When you store parameters, the patch data already in the storage
destination will be erased. Check to make sure you do not need the
patch in the storage destination.
Press the STORE key again. This completes the
storage operation, and returns the 3030 to the Play
mode.
Rather than finally pressing the STORE key, you can press the EDIT
key to cancel storage and return to the Play mode.
To Next Page
Loading...
