■
21
CONTROL THROUGH EXP/VOL PEDAL
Press the PARAMETER key once to select
Parameter 2 (Pedal Mode) .
Depending on where the EXP/VOL pedal is stepped on, this
parameter sets the kinds of changes for the parameter value of
the assigned effect module.
Using the VALUE +/– keys, select mode 1 or 2.
The working of 1 or 2 modes depends upon the effect type
selected by the effect module assigned to the EXP/VOL pedal.
■ When WAH or PEDAL PITCH effect types have been
selected by effect modules assigned to the EXP/VOL pedal
Foot up Foot down
Mode 1 Minimum value → Maximum value
Mode 2 Maximum value → Minimum value
■ When DIST effect types have been assigned to the
EXP/VOL pedal
Foot up Foot down
Mode 1 ( Minimum value for setting)→ Parameter set value
Mode 2 Parameter set value → ( Minimum value for setting)
The minimum value of the distortion gain control varies according to
the type of distortion and the parameter settings. The minimum value
achieved by these changes may be smaller than Gain 1, depending on
the settings.
■ When effect types other than the above have been assigned
to the EXP/VOL pedal
Foot up Foot down
Mode 1 Minimum value → Parameter set value
Mode 2 Parameter set value → Maximum value
■ When Volume has been assigned to the EXP/VOL pedal
Foot up Foot down
Mode 1 Minimum value → Maximum value
Mode 2 Maximum value → Minimum value
When the foot pedal FP01 (optional) is connected to the 3030
VOLUME /MANUAL jack, FP01 will always be assigned as the
volume pedal that controls the volume immediately after EQ2. Hence,
note that for any patch assigned VOL with the EXP/VOL pedal, the
EXP/VOL pedal will not work.
When you have called up a patch set to control effect parameters with
the EXP/VOL pedal, the parameters will not change until the pedal is
moved.
Press the EDIT key again.
The Play mode will be returned. Store any patches as
necessary.
In Play mode, the functions assigned to the EXP/VOL pedal are
indicated by the PARM4 and PARM5 LEDs.
7
To Next Page
Loading...
Need help?
General
