Zoom 5350 - Advanced Wireless Settings

802.1x Authentication
(only available when WEP is
enabled)
Select Enable to enable 802.1x authentication.
Network Key 1-4
You can pre-define up to 4 keys for 64-bit or 128-bit WEP. 64-bit
keys require 10 hexadecimal digits and 128-bit key require 26
hexadecimal digits.
Current Network Key
Select one of the four pre-defined keys as the current network
key.
PassPhase
Enter a word or group of printable characters and click Generate
WEP keys to generate WEP encryption key. These characters are
case sensitive.
Generate WEP Keys Click to generate 4 WEP keys automatically.
DHCP Server Select Enable to deploy DHCP server for this guest SSID.
IP Address
Enter the IP address to be the default cable modem/router
address for clients connected this guest network.
Subnet Mask Enter the subnet mask for this guest network.
Lease Pool Start Enter the start IP address of this DHCP address pool.
Lease Pool End Enter the end IP address of this DHCP address pool.
Lease Time
Enter the leased time for DHCP clients. DHCP clients will resend
DHCP request before expiration. Maximum value is 86400
seconds.
Advanced
The Advanced page allows you to configure advanced wireless settings. Most users will have no
need to change these settings.
To access the Advanced page:
1 Click Wireless in the menu bar.
2 Then click the Advanced submenu.
Figure 37 shows an example of the menu and Table 27 describes the items you can select.

80