Zoom 5350 - Ipsec Menu Option

Table 32. IPSec Menu Option
Option Description
Tunnel
This is a pull-down list of VPN Names defined below. Select the specific
VPN tunnel to configure.
Name Enter a VPN name and click Add New Tunnel.
Local Endpoint
Settings
Configure the local network located at your cable modem/router’s AN
side.
Address Group Type
Define the local address type. Select IP Subnet to protect the whole
subnet; select Single IP address to protect a single PC or device; select IP
address range to protect several PCs, or devices.
Subnet Enter the subnet scale for address group.
Mask Enter the subnet mask for address group.
Identity Type
Select the type to identify the cable modem/router. The choices
are:WAN IP address, LAN IP address, FQDN (Fully Qualified Domain
Name) or Email address.
Identity Enter the value corresponding to the selected identity type.
Remote Endpoint
Settings
Record the parameters of the network on which the peer VPN is located.
Address Group Type
Define the local address type. Select IP Subnet to protect the whole
subnet; select Single IP address to protect a single PC; select IP address
range to protect several PCs.
Subnet Enter the subnet for address group.
Mask Enter the subnet mask for address group.
Identity Type
Select the type to identify the cable modem/router. The choices are
WAN IP address, IP address, FQDN or Email address.
Identity Enter the value corresponding to the selected identity type.
Network Address Type
Enter the IP address or domain name of the peer VPN cable
modem/router. You can select IP address, which is typically suitable for
static public IP addresses or FQDN, which is typically suitable for
dynamic public IP address.
Remote Address Enter IP address according to the Network Address Type.
IPSec Settings Configure the IPSec protocol related parameters.
Pre-Shared Key Enter a key (Pre-Shared key) for authentication.

91