108
Fragmentation Threshold
This value specifies the maximum size for a packet before
data is fragmented into multiple packets. If you experience
a high packet error rate, you may slightly increase the
fragmentation threshold. Setting the fragmentation
threshold too low may result in poor network performance.
Only minor reduction of the default value is recommended.
In most cases, it should remain at its default value of 2346.
RTS Threshold
Using this setting can regulate your wireless network if you
experience any inconsistent data flow. Make only minor
adjustments to the default value of 2347.
Wireless Multicast
Forwarding (WMF)
Enable or disable Multicasting over the wireless network.
Access Control
This page allows you to control which wireless clients can access your wireless network.
It also provides information about wireless clients connected to your access point.
To access the Access Control page:
1 Click Wireless in the menu bar.
2 Then click the Access Control submenu.
Figure 34 shows an example of the menu and T
able 27 describes the items you can
select.
Figure 34. Example of Access Control Page
To Next Page
Loading...
