Zoom H2next - Recording Mode Details and Saving; Selecting Recording Mode; Adjusting Stereo Width (S Level); Selecting Save Location

Recording
Selecting the recording mode
22
Recording
Selecting where recordings are saved
23
H2n Handy Recorder
Selecting the recording mode
1.
Turn so that the triangle points to the desired mode.
2.
Make settings for the recording mode.
Adjusting the S level (MS stereo, 2ch/4ch surround modes)
You can adjust the stereo width (S level) before recording.
•
Use to adjust the stereo width.
2.
Use to select FOLDER, and then
press .
3.
Use to select the folder where you want
to save fi les, and then press .
NOTE
∙ The 4ch surround mode can only be used
when an SD card is in the unit.
∙ In 4ch surround mode, only WAV formats
(44.1/48kHz, 16/24bit) can be used.
∙ In 4ch surround mode, two stereo files
are created (MS mic recording and XY mic
recording).
NOTE
Select from among 10 folders. There are separate sets of folders for stereo and 4ch recordings.
NOTE
Set to OFF, RAW or between –24 and +6 dB.
Wide The graphic changes along with the value Narrow
Selecting where recordings are saved
1.
Press .
Using MS-RAW mode (WAV format only)
If you want to adjust the stereo width after recording, record using MS-RAW
mode.
•
Hold down until RAW appears.