Zoom H2next - Checking Software Versions; Restoring Factory Settings

Various settings
Checking the software versions
80
Various settings
Restoring the unit to its factory settings
81
H2n Handy Recorder
Checking the software versions
1.
Press .
You can view the versions of the system and other software used by the .
2.
Use to select SYSTEM, and then
press .
3.
Use to select SOFTWARE VERSION,
and then press to show the software
versions in use.
System software version
Restoring the unit to its factory settings
1.
Press .
You can restore the recorder to the settings it had when it was shipped from the
factory.
2.
Use to select SYSTEM, and then press
.
3.
Use to select FACTORY RESET, and then
press .
4.
Use to select YES, and then press .
NOTE
∙ The date and time, recording mode and input gain
settings are not reset by this.
∙ This also erases any recording in the built-in
memory.