Using USB
Audio interface use
60
Using USB
Audio interface use
61
H2n
Handy Recorder
Audio interface use
MS/XY stereo and 2ch surround modes only
You can record the signal from the directly to a computer, and output the
playback signal from a computer through the .
1.
Follow steps 1–3 in “Exchanging fi les with a computer” on P.58.
2.
Use to select AUDIO I/F, and then
press .
3.
Use to select SAMPLING FREQUENCY,
and then press .
7.
Use to select YES, and then press .
8.
Disconnect the cable from the computer and the .
6.
To disconnect the recorder, press , use
to select DISCONNECT, and then press .
5.
Use to select CONNECT, and then
press .
4.
Use to select the sampling frequency,
and then press .
NOTE
∙ For information about the menu items that can be used see the following.
LO CUT (➝P.66) PLUG-IN POWER (➝P.16) AUTO GAIN (➝P.70)
COMP/LIMITER (➝P.68) MONITOR (➝P.67) DISCONNECT
MS-RAW MONITOR (➝P.71) TUNER (➝P.62) INPUT
∙ If you want to send signals from the recorder to the computer, set INPUT to
ON in the USB AUDIO MENU.
NOTE
Make sure that the sampling frequency settings are
the same for both the
and the software you
are using.
To Next Page
Loading...
