RT100 Rough Terrain Crane
(5) Do not turn the ignition switch to “0” at this time. Stop the engine and keep electrical
power applied to the engine for 30 seconds to let the engine data transfer to the
ECU. Turn the ignition switch to the “0” position.
Do not keep the battery master switch in the "ON" position after you park
the crane. This will cause the battery to drain, circuit breakdown or
(6) When you park the crane on a slope, you must put chocks on the wheels.
When the battery and engine are not "ON", you can turn "ON" the hazard
(7) To prevent an accident when you park the crane in the dark, you must turn “ON” the
You can decrease fuel use and extend the life of the tires if you follow these points:
Develop good driving habits.
Only idle the engine at a high speed when it is necessary. Make sure that the gear
selector is always at a high gear. When more engine power is necessary, increase the
Do not move the throttle or brake pedal quickly.
Do not turn the crane quickly.
Do not start to move the crane quickly.
The most efficient speed to move the crane is at 3/4 of the maximum.
When you move the crane, keep the engine coolant temperature between 70℃ and 95
When the engine coolant temperature is too low or too high, the performance of
Always make sure that the tires have the correct pressure.
If the tire pressure is too low, the tires wear incorrectly and they increase the load
Keep the operation of the air conditioner system at a minimum.
Always use the correct type of fuel and engine lubricants.
Keep to the preventive maintenance schedule.
To Next Page
Loading...
