RT60 Rough Terrain Crane 07 - 43
Fig. 07 – 46
REMOVAL
Proceed analogously, in the reverse order.
Luff the boom up a little to facilitate dismantling.
(1) Ensure that there are no obstacles / persons within the jib swing range;
Fig. 07 - 47
(2) Set the outriggers and swing the jib over front before assembling / dismantling
the jib;
(3) Do not operate or travel the crane after removing the jib retaining pin on boom
side. Otherwise, the jib may fall off;
(4) Turn the HIGH / LOW SPEED CHANGEOVER SWITCH FOR AUX WINCH to stage
High or Low during jib operation;
(5) Swing the jib to the front working area and luff it down in the -3
° position before
assembly. All assembly and disassembly work from a high position must
generally be carried out by using suitable aids (ladders, stairs, etc.) to ensure
safety;
To Next Page
Loading...
