ZTE H108N V.2.1 Configuration manual
Page 11 ZTE Proprietary and Confidential
Here is the WAN configuration to set in Setup->Internet Setup for the WAN1
connection ("connectivity default"):
VPI and VCI each: 8/32
Service Category (QoS): UBR without PCR
Connection Type: PPPoE
Encapsulation mode: LLC
PPPoE Username: adslppp@telefonicanetpa
PPPoE Password: adslppp
NAT enabled.
Then refer to the Advanced section:
Advanced -> QoS Configuration: these rules are already configured from
factory named as UP_Q_3 and traffic priority is given in the order of this list:
Traffic to the ACS: 80.58.63.192/255.255.255.192.
Traffic for public NGN: 81.47.224.0/255.255.252.0.
Advanced -> Routing -> RIP: rules for 8/32 are turned off.
Finally refer to the Management -> Access Controls -> Services, find the WAN
connection 8/32, and configure the following protection in the table:
Allow ICMP traffic from WAN for all IP address (zero).
Allow FTP, TELNET, HTTP (23, 21, 8000) traffic from WAN for these IP:
IP add = 193.152.37.192,80.58.63.128
Masks = 255.255.255.240,255.255.255.128
Deny all other WAN traffic
2.2.2 Configuration for multi-device with static IP
This configuration mode differs from the previous in that your router is assigned a
fixed IP address through which you will always access Internet.
In management GUI, it can be set on Setup->Internet Setup:
To Next Page
Loading...
