Zte H108N - System Requirements; Features

ZTE H108N V.2.1 Configuration manual
Page 57 ZTE Proprietary and Confidential
 Do not connect this device to a PC or electronic product unless instructed
by our customer engineer or your broadband provider. Wrong connection
may cause power or fire risk.
 Do not place this device on an unstable surface or support.
5.2 System Requirements
 A 10 baseT/100BaseT Ethernet card is installed on your PC.
 A hub or switch when several PCs attached through one of Ethernet
interfaces on the device
 Internet Explorer 7 or higher, Chrome 1.0, Firefox 1.5 or higher.
5.3 Features
 Various line modes
 External PPPoE dial-up access
 Internal PPPoE and PPPoA dial-up access
 Leased line mode
 1483B, 1483R, and MER access
 Multiple PVCs (eight at most) and these PVCs can be isolated from each
other
 A single PVC with multiple sessions
 Multiple PVCs with multiple sessions
 Binding of ports with PVCs
 802.1Q and 802.1P protocol
 DHCP server
 NAT and NAPT
 Static route
 Firmware upgrade: Web, TFTP, FTP
 Reset to the factory defaults
 DNS relay
 Virtual server
 DMZ
 Two-level passwords and user names
 Web user interface