ZTE H108N V.2.1 Configuration manual
Page 24 ZTE Proprietary and Confidential
There is a QRcode square on the right of the page. This QRcode can help your
cell phone connect to the wireless network of H108V automatically. It can also
help you to note down / recover your Wi-Fi’s password if you forgot it.
Note:
Just taking photo of QRcode will not work. Instead you need to have a
reading application, for example: QR barcode scanner (Android), Bidi
(iPhone), BeeTagg (WP7), etc.
2.3.2 Wireless Security
In the Wireless page, click Wireless Security. The page shown in the following
figure appears. The defaulted Security Mode is WPA only in this page. Wireless
security is vital to your network to protect the wireless communication among
wireless stations, access points and wired network.
Note:
Enable Wireless before configuring the wireless security settings in
this page. Refer to 2.3.1 ¡Error! No se encuentra el origen de la
referencia. to enable Wireless.
If the Security Mode is set to be Auto (WPA or WPA2), WPA2 only, or WPA only,
the following page appears.
To Next Page
Loading...
